Best way to patch door knob hole

Discussion in 'General Home Improvement Discussion' started by cmacias925, May 11, 2012.

  1. May 11, 2012 #1

    cmacias925

    cmacias925

    cmacias925

    New Member

    Joined:
    May 11, 2012
    Messages:
    1
    Likes Received:
    0
    Hi, I found a great idea on Pinterest that I want to replicate. However I can not get the person who posted the idea to respond to my question. I need some suggestions please :)

    They made an outdoor shed out of old interior doors. I'm wondering if anyone knows what the best way is to patch the door knob holes?

    Thanks for the help guys!
    Christina

    door shed.jpg
     
  2. May 11, 2012 #2

    GeoffM

    GeoffM

    GeoffM

    Member

    Joined:
    Apr 20, 2012
    Messages:
    21
    Likes Received:
    0
    Cut a chunk of wood the size of the hole, glue and toenail into it?
     
  3. May 11, 2012 #3

    nealtw

    nealtw

    nealtw

    Contractor retired

    Joined:
    Nov 4, 2010
    Messages:
    23,892
    Likes Received:
    3,117
    These are solid wood doors, anything less will not last.
    You would set up a jig for a router. Router out a square about 4" sq about a 1/4" deep and glue in a peice of wood. If the door is fir get a peice of fir. If you where just moving hardwhere you would also plug the whole between the two patches.
     
  4. May 11, 2012 #4

    nealtw

    nealtw

    nealtw

    Contractor retired

    Joined:
    Nov 4, 2010
    Messages:
    23,892
    Likes Received:
    3,117
    BTW, Welcome to the site.
     
  5. May 12, 2012 #5

    joecaption

    joecaption

    joecaption

    Well-Known Member

    Joined:
    Jan 8, 2011
    Messages:
    2,046
    Likes Received:
    295
    I see no way the shed shown in that picture is ever going to work long term.
    They have the bottoms of the doors sitting flat on the patio. Water is going to just be wicked up through the rails and rot out the bottoms of the doors.

    Ever see what happens to a sheds walls when someone has it sitting to close to the ground?
    There's dozens of post on this site and all the DIY sites on what happens to homes when the decking is install right under the doors thresholds.

    That whole thing needed to be built on a platform made of pressure treated wood to get it off the ground.
    From the picture I can not see how there even able to open the doors, it looks like they would just drag on the ground. If you cut them off so it would open there's going to be a big enough gap for insects and mice to get it.
    Also in most cases an int. door is made out of wood that's not rot resistant.
    They also have a dead flat roof that looks like it's made of plywood. Just not going to work out over time.
    When plugging old door knob holes I use plugs cut with a hole saw, mix up some Durham's Water putty instead of glue and apply it around the plugs outside edges, once it hardens You can use the same putty as a wood filler.
    It's sandable, paintable, and as strong as the wood once it hardens.
    It will also work to fix where the latch was.
     

Share This Page