Broken Kitchen Counter (photos inside)

Discussion in 'General Home Improvement Discussion' started by tigersmith, Mar 16, 2010.

  1. Mar 16, 2010 #1

    tigersmith

    tigersmith

    tigersmith

    New Member

    Joined:
    Mar 16, 2010
    Messages:
    1
    Likes Received:
    0
    Hello, I am a guest visiting this forum hoping that you guys can help me.

    The counter in my kitchen broke as a result of being hit by a hard object. I have posted some photos below.

    I am not sure what material the counter is, but it looks to me like marble. Can you guys tell the material from the photos?

    My question is: what is the best way to repair this and what is the estimated cost? (I am guessing that some kind of glue must be purchased)

    Any and all advice appreciated
    - Tiger

    [​IMG]

    [​IMG]

    [​IMG]

    [​IMG]
     
  2. Mar 17, 2010 #2

    Wuzzat?

    Wuzzat?

    Wuzzat?

    Well-Known Member Sponsor

    Joined:
    Jan 20, 2010
    Messages:
    2,471
    Likes Received:
    175
    If you can get access to the underside of the counter in the area of the crack, I think it can be repaired structurally but the crack will probably be visible; is this OK?
    From the photos, you have access to the edges of this countertop, and this may be enough to repair this. The repair needs to be able to stand bending stress.

    You can measure the volume of the piece by submerging it in water, and then weigh it, and compare the measured density with that of marble [2563 kg/cu.m, give or take some].
    A candle flame is 600°-1400°C; you could apply that to the underside at an edge. Marble should be unaffected.
    If it's some composite material, machining instructions supplied by the manuf. would be helpful.

    By default you could try epoxy but the repair won't be able to withstand a downward force.
     
    Last edited: Mar 17, 2010

Share This Page