Building paper soaked and rotted

Discussion in 'Framing and Foundation' started by ziggy, Jun 16, 2006.

  1. Jun 16, 2006 #1

    ziggy

    ziggy

    ziggy

    New Member

    Joined:
    Jun 16, 2006
    Messages:
    1
    Likes Received:
    0
    Hi,

    I've got a bathroom that has water damage in one of the walls of the shower. The water got into the wall from a window seal inside the shower and I believe it came from inside the shower and not outside the house. Anyway we pulled the tiles and sheetrock off and found that everything under the windows was soaked. The insulation was dripping and when we pulled it out some of building paper came off with it. This appears to be the only water barrier that was there (about 1.5 inches of stucco, chicken wire, building paper, insulation, then sheetrock). A few of the 2x4 studs are damaged as well but most look like they're in good condition.

    The house has a stucco exterior and is about 20 years old. My question is how do I go about fixing this? I'd like to replace the building paper so that I get a proper water barrier but in order to do so I'd need to remove all the studs from the wall (about 5ft of wall). The studs are attached to the stucco with small nails and staples so I think I could remove them with some care. However I'm concerned about the effect this would have on the stability of the wall (i.e. would I need to re-attach the stucco wall to the 2x4's and if so how?) Are there any other options that would not require the removal of the studs?

    The wall is on the East side of the home which is the most protected from the weather however we do get a fair amount of rain during the winter time.

    Thanks in advance for your help,
    Ziggy
     
  2. Jun 16, 2006 #2

    inspectorD

    inspectorD

    inspectorD

    Housebroken Staff Member Admin Moderator

    Joined:
    Dec 17, 2005
    Messages:
    4,502
    Likes Received:
    267
    I would almost say call a pro in on this one. Without being able to see your situation it can be tough to give you the "right" answer.See what they propose and if you feel you can do it yourself...geter dun....The one thing I would always do is to remove the window from the shower in the future. Then install a fan in the ceiling of the bathroom and vent it to the exterior, not the attic or soffits, you don't need more trouble.:D

    Welcome to the forum.
     
  3. Jun 18, 2006 #3

    glennjanie

    glennjanie

    glennjanie

    Well-Known Member

    Joined:
    Mar 1, 2006
    Messages:
    2,990
    Likes Received:
    4
    Hello Ziggy:
    I would just like to add a line or two to InspectorD's answer. I would not try to take any studs out for the reason you said. You might consider some 4mil polyethelene over the studs and the inside of the outside wall. That will leave your studs in the outdoor moisture but it will protect the inside. Also I definitely agree on getting rid of the window; every opening is a potential leak.
    Glenn
     

Share This Page