Cement door sill

Discussion in 'Windows and Doors' started by goser, Jan 19, 2010.

  1. Jan 19, 2010 #1

    goser

    goser

    goser

    New Member

    Joined:
    Jan 19, 2010
    Messages:
    2
    Likes Received:
    0
    I am replacing my old front door with a prehung steel door. Currently I have a concrete sill which wraps right from the inside of the door to the outside and around the brick. In winter, this sill is a fantastic transferrer of heat, and I always wind up with condensation and mould on the inside edge of the sill. It looks like a massive undertaking to replace the whole sill, and my new door frame and sill will fit into the opening with merely grinding down the 'hump' on the cement sill. My best idea at the moment is to cut a trench in the cement sill underneath where the new wood/aluminium sill will rest and fill it with spray insulation as a thermal break. Just wondering if there is another common solution to this, and looking for thoughts and opinions on my plan.
     
  2. Jan 19, 2010 #2

    GregC

    GregC

    GregC

    Quick Belt System

    Joined:
    Jan 10, 2010
    Messages:
    82
    Likes Received:
    0
    Hello, I have done only a few of this in all my time but I did just that. I Ground down the hump to flatten it out. I then used adhesive caulk down on concrete, applied foam "sill seal" and then set the new door in another bead of caulk. Finishing with small bead of caulk inside and out. Has worked fine for me in the past. Shouldn't be a problem. I have installed several patio and entry doors the same way on basement slabs or garage slabs and they all seem to be fine. Use the "sill seal" along with your foam or caulk. Be sure you use a DAP low expanding foam or others will tend to heave the door sill. ;)Good Luck, Greg
     
  3. Jan 20, 2010 #3

    goser

    goser

    goser

    New Member

    Joined:
    Jan 19, 2010
    Messages:
    2
    Likes Received:
    0
    Thanks for the reply. Just out of curiousity what did you use to grind down the sill?
     
  4. Jan 20, 2010 #4

    GregC

    GregC

    GregC

    Quick Belt System

    Joined:
    Jan 10, 2010
    Messages:
    82
    Likes Received:
    0
    Hello, Good ol 9" Angle grinder with a concrete stone wheel. It takes a bit of time depending on how much of a lip or bevel you have there in the concrete but it does do the job. Good Luck, Hope this helps.:cool: GregC
     

Share This Page