Do I need a new tool?

Discussion in 'Flooring' started by gfw, May 19, 2008.

  1. May 19, 2008 #1

    gfw

    gfw

    gfw

    Member

    Joined:
    May 15, 2008
    Messages:
    17
    Likes Received:
    0
    I need to cut a rectangle out of chipboard that's in a very awkward location.
    A total of maybe 4 feet of linear cutting. Would the standard spiral cutting bit on a Dremel do the job, or is chipboard too heavy? I'd rather not have to buy a jigsaw and work with it in this awkward location.
     
  2. May 19, 2008 #2

    Daryl in Nanoose

    Daryl in Nanoose

    Daryl in Nanoose

    Well-Known Member

    Joined:
    Feb 3, 2006
    Messages:
    768
    Likes Received:
    9
    Yes it will work just take a little out at a time so your not overworking the tool or the bit.
     
  3. May 20, 2008 #3

    rachael24

    rachael24

    rachael24

    Active Member

    Joined:
    Apr 29, 2008
    Messages:
    37
    Likes Received:
    0
    I dont see why it wouldnt work either...like Daryl said, take you time.
     

Share This Page