Finishing a basement

Discussion in 'Introductions' started by rdford60, Jan 17, 2006.

  1. Jan 17, 2006 #1

    rdford60

    rdford60

    rdford60

    New Member

    Joined:
    Jan 17, 2006
    Messages:
    1
    Likes Received:
    0
    I want to put up foam insulation under the 2 x 4's on a basement wall. Then put up sheet rock. Can you put down the foam then 2 x 4's on top? If so what is the best way to attach it?
     
  2. Feb 2, 2006 #2

    MinConst

    MinConst

    MinConst

    Well-Known Member

    Joined:
    Feb 2, 2006
    Messages:
    49
    Likes Received:
    0
    You would be better off building your walls with 2x4s and then insulating between the studs. Leaving a 1" or gap between the new wall and your foundation wall. This will allow air flow behind the wall to allow any dampness to dry. Insulate with either foam board or normal R13 with the vapor barrier toward the finished room.
     
  3. Feb 3, 2006 #3

    inspectorD

    inspectorD

    inspectorD

    Housebroken Staff Member Admin Moderator

    Joined:
    Dec 17, 2005
    Messages:
    4,502
    Likes Received:
    267
    Hey folks,
    We always here would you like paper or plastic at the market?
    Well in building terms this can be a whole diferent senario.
    Minconst made a good point about where the vapor barrier goes, (Welcome buy the way!) and I would like to elaborate a bit further because it will help you live healthier.
    When you insulate the basement the best method is to use styrofoam insulation,as mentioned.Because it can hold no moisture.Fiberglass insulation uses trapped air to form the thermal barrier which can also trap moisture and mold.I assume you wanted to use foam for this reason.
    Now getting to my point,if anyone uses fiberglass for the insulation ALWAYS use kraft faced paper not plastic for a barrier.
    The plastic when used in the basement WILL trap the moisture in the fiberglass insulation. Paper actually absorbs some of the moisture and releases or lets it pass through and trys not to keep it.Therfore it is a smart vapor barrier. Foam does not need any barrier however if you can adhere the foam to the backside of the wall and leave the airspace, that would be best.

    Always put a dehumidifier in your finished basement.
    Stay dry,
    Brian::D
     

Share This Page