Garage Door

Discussion in 'Bricks, Masonry and Concrete' started by StevePeel, May 3, 2011.

  1. May 3, 2011 #1

    StevePeel

    StevePeel

    StevePeel

    New Member

    Joined:
    May 3, 2011
    Messages:
    2
    Likes Received:
    0
    I'm wanting to add a garage door to my existing carport which is block construction. The home was built in the 50's and the cells around the opening are not filled with concrete. Additionally, there is no block header, just a wood header spanning the top of the opening. The city is requiring a detail of attachement that meets wind load specs. I need to be pointed in the right direction for submitting a plan and actually engineering the opening and a header that matches the height of the door itself??

    Thanks in advance - SP
     
  2. May 3, 2011 #2

    nealtw

    nealtw

    nealtw

    Contractor retired

    Joined:
    Nov 4, 2010
    Messages:
    23,897
    Likes Received:
    3,118
    If the city said they want to see engineering, they usually want to see an engineers stamp on the plan. If that is the case you need an engineer.
     
  3. May 3, 2011 #3

    StevePeel

    StevePeel

    StevePeel

    New Member

    Joined:
    May 3, 2011
    Messages:
    2
    Likes Received:
    0
    They only want a detail. I am looking for a way to do the work that they might approve.
     
  4. May 3, 2011 #4

    nealtw

    nealtw

    nealtw

    Contractor retired

    Joined:
    Nov 4, 2010
    Messages:
    23,897
    Likes Received:
    3,118
    Hopefully someone that knows this stuff will come along to help you out.
     
  5. May 4, 2011 #5

    inspectorD

    inspectorD

    inspectorD

    Housebroken Staff Member Admin Moderator

    Joined:
    Dec 17, 2005
    Messages:
    4,502
    Likes Received:
    267
    Florda and Cali are the two states in the country with certain codes that make life interesting. Depending on what your Inspector wants to see, you will most likely need an engineer as suggested to figure what you have there in the first place. Remember that the inspector does not come out to look at the job till it's finished. By then, if it is done wrong or you missed that there is no rebar and grout in any of the cells, you get to tear it out and start over.

    I attached a link which may help, but If this was my job, I would go with the $400 or so , and save a big headache.
    Good luck:)
    http://www.toolbase.org/PDF/CaseStudies/concrete_masonry_homes.pdf
     

Share This Page