Am I too demanding? I'd like our new french doors installed flush to the drywall so when trim goes over it is nice and flat. This is clear natural pine casing and the same mat'l for the door so we aren't puttying and painting. On the first install attempt, one set of doors was off level 3/8 in 5 feet along the top. It was corrected. Its edges are flush to the drywall (by chance?). On the other set of doors, one side is sticking out 1/8 to 3/16 past the drywall. I'm not a trades pro but I bet I could make it flush all around--can I expect my guy to to likewise? I don't want gaps under the trim/casing once it's in. Thanks.