In progress vinyl fence

Discussion in 'General Home Improvement Discussion' started by tractng, Jul 6, 2011.

  1. Jul 6, 2011 #1

    tractng

    tractng

    tractng

    Well-Known Member

    Joined:
    Jul 2, 2007
    Messages:
    198
    Likes Received:
    9
    I have a retainer wall that is about 3 blocks high from the ground. I already did about half the work but still unsure if I did it correctly.

    On the block that I needed a post in which it already had concrete, I used a 3/8" (3" 3/4 long) wedge anchor and a post bracket. My wood post is only 4 feet high (the vinyl post is 6 ft).

    On the block that didn't have concrete, I filled the block up with concrete 2 blocks deep and used 24" rebar. I then placed a 4" inch hex bolt with a washer into the concrete. I should used the anchor bolt with the "j" or other better methods?

    Btw, I am in socal.

    [​IMG]

    Remaining :

    [​IMG]
     
    Last edited: Jul 6, 2011
  2. Jul 6, 2011 #2
    So far so good.
     

Share This Page