Installing door in new construction

Discussion in 'General Home Improvement Discussion' started by Will, Jun 18, 2006.

  1. Jun 18, 2006 #1

    Will

    Will

    Will

    Active Member

    Joined:
    May 28, 2006
    Messages:
    29
    Likes Received:
    0
    Hi
    This may seem like a kind of obvious question but I'm wondering - the standard door frame width, without jambs, is 32 inches right? well if I have some new construction I'm doing with studs 16'' on center, it seems to me if I just knock out one stud I'll have the 32 I need.Of course that'll be on center, not inner edge to inner edge, of the studs. Should I just move one of the studs over slightly to get the 32, or should I move bothe of them out a good 1 and 7/8 inches (to make room for cripples that will then make it 32.) In other words I guess what I'm asking is does every door have to have cripple studs? or could I just use the existing studs with a header since its so close to the width it needs to be.


    Will
     
  2. Jun 19, 2006 #2

    inspectorD

    inspectorD

    inspectorD

    Housebroken Staff Member Admin Moderator

    Joined:
    Dec 17, 2005
    Messages:
    4,502
    Likes Received:
    267
    When you frame for an opening, whatever size the door happens to be....you need to add 2 1/2 inches for the rough opening to have the least amount of problems.
    Example...your 32 inch door is the actual size of the door slab itself.
    Now yow need to add the jambs which are 3/4" each side.
    Next you need a 1/8 inch gap on each side of the door slab, between the door and jambs to open and close the door.
    Next you need a 3/8 " between each door jamb and the jack stud ( not cripple,or headers those are at the top of the door),left and right sides, to shim the door so it is plumb in the opening and has room for movement once the new construction starts to move.
    so 3/4 jamb+ 3/4jamb= 1 1/2
    1 1/2 of jambs + 1/8 gap+ 1/8gap= 1 3/4
    1 3/4 + 3/8gap at studs + 3/8 gap at studs = 2 1/2" total added to a 32" door equals a 34 1/2 inch rough opening.
    So no you "Will" not make it with just removing a stud.

    You need to lay out all your doors and windows on center then do you 16 on center.

    Try a framing book at your local library...they are free.:D
     

Share This Page