Insulation in cold air return?

Discussion in 'HVAC' started by Caulkmaster, Oct 11, 2010.

  1. Oct 11, 2010 #1

    Caulkmaster

    Caulkmaster

    Caulkmaster

    New Member

    Joined:
    Oct 11, 2010
    Messages:
    1
    Likes Received:
    0
    Hi, all - I just bought a house from the '40s which uses ducts that are built into the support beams, Opened up cold air intake to clean it before turning on heat, and saw that it was full of insulation. That's not good, riight? Or does the filter on the heater remove any air contaminants?
     
  2. Oct 11, 2010 #2

    havasu

    havasu

    havasu

    Guest

    I have limited knowledge myself on this topic, but will throw in my two cents anyway. This would be better left for a professional with lots of knowledge in duct work. Many ducts from that era contained asbestos, and you don't want to disrupt it without proper safety precautions. It may be possible to reline your original ducts or reroute them, but get a professional opinion from someone in person.
     
  3. Oct 21, 2010 #3

    classic

    classic

    classic

    Member

    Joined:
    Apr 27, 2006
    Messages:
    9
    Likes Received:
    0
    if this is loose insulation in an unlined return, the return suction pressure has pulled the insulation in from the attic or walls. This means that your return trunk is not airtight and your efficiency has dropped. Vacuum the insulation out. Seal it if possible

    If it is blanket type insulation, it was origionally attached to the walls of the return line, and this is blocking return air from getting back to the unit

    If these ducts are nuninsulated they are VERY inneficient.
     

Share This Page