Need paint advice: calling Nestor

Discussion in 'Painting Forum' started by travelover, Jul 27, 2009.

  1. Jul 27, 2009 #1

    travelover

    travelover

    travelover

    Well-Known Member

    Joined:
    Aug 5, 2007
    Messages:
    693
    Likes Received:
    2
    My wife wants to repaint a bathroom cabinet that is currently Oak with a clear finish. As she wants a brush free finish, she wants to spray paint it from cans. What choice of primer and spray paint would guarantee no (bad) interaction between the current finish and the new paint?

    Thanks!
     
  2. Jul 28, 2009 #2

    Nestor_Kelebay

    Nestor_Kelebay

    Nestor_Kelebay

    Emperor Penguin

    Joined:
    Mar 29, 2009
    Messages:
    1,844
    Likes Received:
    2
    Well, if the cabinet already has a varnish or primer on it, then you wouldn't normally need to start with a primer. Typically, you only need to prime over bare materials, like bare wood, bare drywall or bare metal.

    Since the shelves of this cabinet will be a working surface, you need to use a paint that will dry to a HARD film to stand up better to scuffs and such, so that would mean using an oil based paint, but that would mean you'd also have to contend with some yellowing in that paint because there won't be much natural sunlight in a bathroom.

    If she doesn't mind the yellowing, and you can convince her to go with another clear coat, what I'd suggest is to try a "Wiping Polyurethane" that you can buy in any hardware store or home center. These polyurethanes dry to a hard film, but they're very thin as they're meant to be applied with a rag. Basically, you put on a rubber glove, get a rag wet with the wiping poly, and wipe it on your cabinet. You keep the rag in a tightly closed plastic bag with a minimum of air in it between wipings, and you keep wiping until you get a nice gloss on the piece.

    If it's gotta be paint, then all I can suggest is to thin any oil based paint with a product called Penetrol (made by the Flood Company and also available at any hardware or paint store) and apply the paint with a small 3 inch roller to get the smoothest non-spray paint job you can get. Depending on the roller you use, you might still need to use a brush to apply the thinned paint in the corners.

    If it's gotta be a spray paint, then about all I can suggest is that you spray it with smooth even strokes and don't start or stop spraying in the middle of a stroke. Also, to avoid spraying on so much that the paint sags as it dries (which gonna look like he11), apply multiple thin coats of spray paint to avoid that problem.

    Sorry I couldna been of more help.
     
  3. Jul 28, 2009 #3

    travelover

    travelover

    travelover

    Well-Known Member

    Joined:
    Aug 5, 2007
    Messages:
    693
    Likes Received:
    2
    Thanks, Nestor - good advice as always.
     
  4. Jul 28, 2009 #4

    inspectorD

    inspectorD

    inspectorD

    Housebroken Staff Member Admin Moderator

    Joined:
    Dec 17, 2005
    Messages:
    4,503
    Likes Received:
    267
    Another tidbit , You really should scuff the existing door finish with a 220 grit snadpaper as best you can. This will help the new paint to adhere a little better. Getting off the top clearcoat with all the other cleaners and junk adheard from use has always made my jobs come out lasting longer.
    Sand as best you can and clean up any dust with a tack cloth when you are finished.:2cents:
     

Share This Page