possible frozen coil but a/c unit fan outside comes on only when set to 'cool'

Discussion in 'HVAC' started by xlbwx, Jun 19, 2011.

  1. Jun 19, 2011 #1

    xlbwx

    xlbwx

    xlbwx

    New Member

    Joined:
    Jun 19, 2011
    Messages:
    1
    Likes Received:
    0
    I recently turned my air conditioning on but within a week or two it has stopped working. It started off working fine, then it seemed to be working at half capacity, and now no air blows from the vents. After reading a few other forum posts I think it might be that air flow became restricted because there was no filter on the air intake vent (oops!) and the coil may have frozen up. I've read that in order to fix this you should just run the fan only for a few hours to thaw out the coil. Problem is the fan does not come on unless it's also set to 'cool'. Maybe I'm just not understanding the controls properly, which would be awesome. There are two control switches on the thermostat: one that is marked FAN and can be set to ON or AUTO and one that is marked SYSTEM and can be set to COOL, OFF or HEAT. And then of course there's the little switch/lever thing to choose a temperature. The only time I can hear/see the fan in the unit outside come on is if the themostat is set to system: cool and a temperature that is pretty low (it doesn't matter if fan is set to auto or on). But like I said, that just gets the fan outside going and no air actually comes through the vents. And unless I am misunderstanding, I believe the way to thaw the coil is by having the FAN: ON and SYSTEM: OFF, right? Thanks for any help you can offer! I hope this was descriptive enough!
     
  2. Jun 20, 2011 #2

    kok328

    kok328

    kok328

    Well-Known Member

    Joined:
    Nov 20, 2007
    Messages:
    2,755
    Likes Received:
    249
    turning on the fan without having the A/C running is a quick way to thaw a frozen evap coil but, if you having trouble creating that combination then just turn your system off completely.
    However, you may want to visually inspect the evap coils and verify that they are froze up. It could be that they are just dirty/clogged and need to be cleaned. If they are frozen then thaw them and clean them, verify that you have a clean fitler installed and that the blower motor is running. If they continue to freeze up after that then you most likely have a low freon charge on the system due to a freon leak and will need to have freon added to the proper level.
     
  3. Jul 7, 2012 #3

    moshei

    moshei

    moshei

    Member

    Joined:
    Jul 3, 2012
    Messages:
    16
    Likes Received:
    0
    Its just need cleaning because you never use it for a while. Check everything before you go to the technician.
     

Share This Page