Ok I just realized that I posted this in the wrong dang forum on accident, so let me try again. I am working on a small 600 sq. ft pier and beam house that has some major problems. The structure consists of a main part that measures 24'x24' and an addition to one side that measures 10'x20'. I want to try to do the entire job myself due to the fact that money is really tight right now, and I feel that the building is small enough that it is possible. For starts, the entire structure needs to be raised about 2 ft. The problem is that there is a large portion of the house that is directly on the ground due to either the person that built it not building it high enough or the piers sunk into the ground because it wasn't prepared right. To make it more difficult the floor framing was not built right according to what my experience tells me. Instead of having a sill beam, then floor joist framing, the builder simply put his end joist across the pierstones. This has led to the end joist rotting on one side and the subfloor sitting on the piers. Of course this is the side that is sitting on the ground. So... Here are my questions. First how do I gain access to underneath the house where it is sitting on the ground without having to tunnel completely under the house? Second does anybody have any experience raising a small house like this and how did you do it? Third should I correct the foundation framing in the process of raising and leveling the house? Four In all who answers opinion when is a house just too far gone to save? I've seen restorations where it appears that the entire floor framing is removed and replaced. While not worthy of being a "restoration" that might be the technique I need to use in order to save this house. How do they do that without losing structural integrity of the building?