Hi folks. I just finished replacing a desk lamp turn switch with one of these: http://www.ebay.com/itm/261366459744?ssPageName=STRK:MEWNX:IT&_trksid=p3984.m1497.l2649 Just want to make sure I'm not doing anything unsafe. Here is how I wired it up: Then I put on some electric tape: These things came off the old switch, I'm assuming they're like electric tape? I didn't put them back on because they're in such bad shape: I couldn't get the wire clamp back on where the wire goes into the housing, but there is a rigid connection below and it doesn't move much so I'm thinking I'm ok: How did I do? Thanks for looking!