Warped,squeaky wood floor-radiant heat

Discussion in 'Flooring' started by oldhouse, Feb 17, 2009.

  1. Feb 17, 2009 #1

    oldhouse

    oldhouse

    oldhouse

    New Member

    Joined:
    Feb 17, 2009
    Messages:
    1
    Likes Received:
    0
    I have a 100 year old farm house I have ben remodeling. I installed staple up radiant heat in an an upstairs MB. The floors are the original 1*6 pine T&G flooring over joists at 16 inch centers. This is the second winter for this system. The flooring has a considerable crown and it squeaks just about everywhere you walk on it. The obvious solution is tear out the floor and start over but the downstairs area is completely refinished and I don't want to tear out that ceiling to. My floor refinish guy says the crowing isn't a problem for him to deal with but the squeaking is driving me crazy. I'm not opposed to surface nailing if I thought it would work or how long it would last. I heard something about injecting an adhesive but not really familiar on how that would work.The remainder of the upstairs has the same flooring which has been refinished with just an ocassional creak one would expect in an old house. HELP
     
  2. Feb 17, 2009 #2

    glennjanie

    glennjanie

    glennjanie

    Well-Known Member

    Joined:
    Mar 1, 2006
    Messages:
    2,990
    Likes Received:
    4
    Welcome OldHouse:
    A floor installed 100 years ago doesn't have cement coated nails or screws in it. The old fashioned shiny nails are terrible about backing out and causing sqreaks. I'm thinking you could use one stainless steel screw in the center of each board on each joist to take care of the crowning and the creaking. You could even countersink the screws a bit and use a wood plug over them to hide the head.
    The adhesive thing would help movement between boards causing the creaks but it is very tedious and I don't think you will need it with the new screws.
    Glenn
     
  3. Feb 17, 2009 #3

    GreenIsGood

    GreenIsGood

    GreenIsGood

    Howdy Ya'll!

    Joined:
    Feb 16, 2009
    Messages:
    29
    Likes Received:
    0
    Yep - screws are best for squeaky wooden floors. My dad always used them when putting in a subfloor. They do work.
     
  4. Feb 8, 2013 #4

    cakowba

    cakowba

    cakowba

    New Member

    Joined:
    Feb 8, 2013
    Messages:
    1
    Likes Received:
    0
    Where you ever able to stop the squeeking on your floor. The radiant heat is moving our wide pine boards all over the place - squeeking and huge gaps between them. Any luck
     
  5. Feb 8, 2013 #5

    nealtw

    nealtw

    nealtw

    Contractor retired

    Joined:
    Nov 4, 2010
    Messages:
    23,891
    Likes Received:
    3,117
    You can't do much about board shrinking when they dry out but to stop the squeaks try toenailing finish nail. Nails on an angle stops the wood from moving up and down. That's what they did before anyone used screws.
     

Share This Page