Hello,
I will be ripping out 2 windows that are 4x4 and replacing one window the same size. The other window will be replaced by a 5 ft french door.
I have install a few pre-hung doors and also a sliding patio door in the past. Here are some questions I am asking.
1) What is the best method to break the stucco? In the past, we just used a saw to cut the stucco wall. I am trying to avoid this method as it produce a lot of dust. Probably hammer or pick?
Also, how much stucco do I have to break? I am thinking about 5-6 inches more than the opening for black paper/mesh wire and flashing.
2) My french door is 59.25" and 79.5", my rough opening will be extra 1/2" on each side?
3) Do I still use the 3 coat method (for stucco) once I am done?
- scratch, brown, finish
I will be ripping out 2 windows that are 4x4 and replacing one window the same size. The other window will be replaced by a 5 ft french door.
I have install a few pre-hung doors and also a sliding patio door in the past. Here are some questions I am asking.
1) What is the best method to break the stucco? In the past, we just used a saw to cut the stucco wall. I am trying to avoid this method as it produce a lot of dust. Probably hammer or pick?
Also, how much stucco do I have to break? I am thinking about 5-6 inches more than the opening for black paper/mesh wire and flashing.
2) My french door is 59.25" and 79.5", my rough opening will be extra 1/2" on each side?
3) Do I still use the 3 coat method (for stucco) once I am done?
- scratch, brown, finish
Last edited: