Edh, no there wasn't any GFCI's on it just a regular 20 amp breaker and just regular outlets with small holes exposed to the weather. I feel like an idiot for not paying closer attention. The boxes looked terrible inside. The insulation on the wires themselves was pretty dried and cracking, at...
Thanks I will use the ohm meter and check it out to see if I can isolate where the short(s) are. Thanks. I will let you know what I find.
With looking at the work, I am about set on just running new conduit and wire making sure it is all well sealed.
Is it likely that the new GFCI breaker is bad even though it seems to work fine until I get past point A?
Using a GFCI tester is outlet #1 it shows that it is wired correctly and breaks properly when the test button is pushed. It breaks just as the test button on teh GFCI breaker itself.
If...
If I disconnect at point A, it holds with switch #1 connected and with switch #1 disconnected. Once I connect the switches just past point A, it holds until eithwr one of them are closed.
Also the outlets are wired in parallel not series. I assume even with this that GFCI would work fine unless there is a short to ground somewhere. Which by the test removing the Load Neutral at the GFCI breker would mean the Power line is shorted somewhere??
I now realize that my outside circuit should have been GFCI protected all along. I didn't pay enough attention when some landscapers wired the outside lighting. I regret not watching them more closely now.
I replaced an outside 20 Amp breaker with a GFCI breaker. The breaker immediately...