Recent content by Krebstar

Hi everyone, I was rooting around last night in my utility room and I think I'm just going to hard wire the transformer. I think its going to be the easiest route and its what the manufacturer recommends. There is a nearby light I can tap into and At only .5A for the unit, I think it would be...

I will verify the breaker when I get home. There is a chart on the front of the unit listing amperage. I'll snap a picture when I get home. I will also see if I can figure out what the wire combination coming into the unit is. I will say that I really don't want to mess with the incoming...

(1) Sorry about that. The manual had the diagrams for both 240v and 480v. The correct one is attached below. Right now I'm assuming its 240v until I can actually get in there and inspect. (2) From what I can see it looks like the furnace has a built in transformer to create the 24v (T1). (3)...

Hello, I just purchase an Aprilaire 500a whole home humidifier. While I wait for it to be delivered, I have been familiarizing myself with the installation process. I'm looking at the wiring section and I have a few questions for those who can help. The typical wiring for this unit is to...

OK, so the other day I tried to wipe the trouble areas with a microfiber cloth and the stains went away and haven't come back since. I tried taping a piece of plastic over another area, but haven't seen any condensation build up as of yet. Keeping an eye on things and trying not to change my...

Thanks for the tip! I now have the couch in the center of the room to try and get some adequate airflow back there. Its odd I even made spacer blocks that keep the couch off the wall so you when you recline, you don't scuff the paint on the wall. Maybe its still not far enough? I wonder if...

Hi Everyone, Last night I was moving my couch away from the wall in the basement and I noticed weird discolored spots in the paint finish. I repainted the basement this past winter and this is the first I have seen it. The discolored paint isn't happening anywhere else in the base, just...