I have a HEIL oil furnace (MODEL 867.741454) with WAYNE MSR burner.
No tuneups or anything in the last 3 years not even a filter change.
On start up this winter black soot thru every vent and every wall is now covered.
I checked the pipes to the chimney there was 1/2" of soot The clean...
gas stove has 5- 10 ppm of carbon monoxide cigarete SMOKE EXHALED has 20 ppm.
So yeah if you had a 3 room apt and slept next to the gas stove every night in about 5 years you may get a headache.
OSHA ALLOWS 35 PPM IN AN 8 HOUR DAY WITH A CEILING LIMIT OF 200
SERIOUSLY if you use...
I,m gonna assume you considered the rock and grate plus leveling the floor. to make it easier if your gonna pour a 6" slab then i would use 1x6 boards.
2 ways
1st you can use the 1x6,s on all 4 sides then fill in after it dries
2nd you can use 2 1x6 on the inside corners and just...
more then likely whoevr instaslled the jacuzzi didnt do a good job if the piping is pvc then they didnt glue it right if its copper then it wasnt sweated right.
However I WOULD GET AN ADJUSTER and review the policy then i would ask a diffrent plumber to come in and inspect the work that was...
That is a nicely designed and laid out room. So in being with my radical styles.
First I would tear out the wooden shelves and replace them with glass then use a 3" dead center of the square . For the fireplace I would go 1' In from the outside edges and 3' from the wall. I would also go...
SERIOUSLY ???? $1000.00 FOR a table saw your not gonna use much? You either have too much money or not enough freinds lol.
Pick up a craftsman for 250.00 buy the 5 year extended warranty for 50.00. DONE DEAL.
I have used both types air and gas. The air is a lot faster cause you only have to change out nails. However I prefer the gas type cause it allows me to work later (noise ordinace with a compressor runnin) It also packs up faster. EXCELLENT CHOICE FOR INSIDE USE. The two i have used are...
GHOST???
A) BAD BREAker
B) A SMALL PART OF THE WIRE HAS BECOME COOKED THE REASON IT SEEMS TO "CHARGE UP THEN POP" IS ALONG THAT WIRE SOMETHING HAS COME IN CONTACT WITH THE COPER (DURING REMODLING ITS NOT UNCOMMON TO STRAFE A WIRE USUALY BY A NAIL) AND HAVE THIS PROBLEM CHECK THE...
For starters you should be adding up the watts from the lights. However in a past job i did what you did. then the inspector showed up and i had to tear everythig out . reason being is. The breaker will allow 20 amps thru, the 12 ga can handle that, the 14 ga is made for 15 amp. amp x...