It's a FloTec. Switch is Parts2o (30-50)
Submersible. 130' down.
Tank pressure should be about right. I "topped it off" last fall after 14 years of maintenance free use. Cycle time seems to be about the same.
No additional reducer needed on replacement. 1 1/2" schedule 80 PVC
The corner of the basement where the pressure tank is located.
It's a one-time klunk every time the switch comes on.
It's still the original check-valve.
Only when it kicks on.
I wouldn't think it would be water hammer. Because it only started after I replaced the pump.
Logical?
(And the pressure tank is three feet from where the line enters the house.)
I recently replaced my 1/2 HP well pump with a 1 HP well pump. Why? Because it's what was readily available at the time...
Now, when the pump kicks on, I get a loud bang . I'm thinking I can either 1.) install some type of "start-up pressure absorber" device on the water line, or 2.)...