Recent content by Radioman

Thanks petey_racer I figured that I would have to find another source of power for that receptacle. Thanks Again Radioman

Yes I was there yesterday and I only have two sets of wires. The one new receptacle wires and the other set comes in live to the switch. So any suggestions how to make it work. Thanks Again Radioman

But connecting like you are saying it will only make the receptacle work only when the switch is on. I would like the receptacle to be on all the time. Radioman

You got the 14/2 wire coming from breaker and 14/2 from the light. Everything meets in the box where the switch is . Thanks Radioman

Hello The sensor switch has two black wires coming out of it. Before I started I checked another receptacle on the same circuit to see what side the hot was on it is the right side. So that is how I hooked this one up. Yes I did black to black and white to white. Radioman

Hello Again I just looked at the tester I talked about. And there is a discription of what each light means. It was 1 red and 1 yellow it says HOT/GRD Reverse. Radioman

Thanks petey racer Okay so yesterday I put the receptacle box below ran 14/2 wire from the sensor switch to receptacle hook everything up everything worked. But I took one of those tester you plug in to the receptacle you know with the1 red and 2 yellow lights on it to see if is is wired...

The power comes in the box from the breaker from there its wired into the sensor switch. The switch has a auto/on from there its goes to control three fluorescent light in each light it has two tubes.

Hello All I want to put a new plug in the wall below the sensor switch this sensor switch powers three lights. There is no other source of power anywhere that I can the power from. Is it possible to get power from this switch that is above. And if so what are the steps. Thanks Radioman

Hello All Getting back to the ceramic shower enclosure I have completed it I used the schluter shower system for this project worked out great thanks for everybody input. Thanks Again Radioman

Hello Glennjanie The door is steel and only 9 years old. Thanks Radioman

Hello All I have a 16 foot garage door and what I've noticed in the past 4 months is one side of the door does not completely go to floor. So actually once the door is shut by the garage door opener the one side you can see day light it is up by about half of a inch. Also I put a level on...

Hello All I want to redo my bathroom I am gutting down to the to by fors. I want to have a ceramic shower. Does anybody have input on this is there special grout to use so things do leak. Any suggestions would be helpful.. Thanks Again Radioman