Recent content by serpentine5

cool, thanks

not a bad idea.... thanks.. and no, havent checked prices... I figure I will find one that folks here will give a thumbs up on, and then work on getting one at a good price....

hat last one hasnt gotten back with me... how does this one sound? Paint Sprayer

How about this one? If it works..... Spray tech-Apex series-Model 1620 Paint sprayer

say I wanted to build a little room inside of my garage, heat and cool this room, and I would want to put a 36in door on this room, would you recommend an exterior door or do they make insulated internal doors?

My compressor is rated 9cfm at 40 psi and 7cfm at 90 psi, i can run 90-125 psi constantly all day... I use it to run my air tools; grinders and chisels and such... so I am not worried about it running a paint gun... That being said, i dont know anything about paint guns, so that why I am...

Come spring, I am looking to get a backhoe in here and put in some french drains and attempt to bring in some clay to top everything off but thats down the road.... but right now I need to get these holes closed up before I finish the wall and close it in. Would hate to have to get in there...

LOL, makes perfect sense. Thanks for explaining that Redwood.

you might be right, the frost line here is only 18 inch, and like I said, everything is required to be below it.

cool, thank you much. The joints are less than 3/16 so I got the unsanded. I will probably get to work on this later this week. Have several other projects going on right now and dont want to start another one just yet. Will post back how I did.

ok, thats the thing, I do not want to have to thin the paint or anything, just pour it into the the sprayer and use it. Looking at both interior and exterior.

Why airless? I have a nice air compressor and was hoping to use it to run a paint gun.... What does Sears have that you would recommend?

I have used and installed pex a few times, and it has held up awesomely. I have done both trunk and branch and homerun systems. if you put the manifold as centrally as you can, or closer to the area it will be used most, you wont have any issue with long extended waits for hot to comeout. It all...

are you asking about the connections from the hot and cold knobs to the diverter knob? or not having hot and cold knobs and goign directly to the diverter? you would get water (hot and cold both) coming out of the shower and tub constantly without any way of shutting it off. now if you plugged...

are there any air compressor paint guns at Harbor Freight that work with both oil based and latex that anyone here would recommend? Looking to do both interior and exterior painting with it. Would probably also use it for stains and varnish sealing of outdoor wood.