I'm working on my kitchen and I removed some drywall. My drywall is foil backed and I'm not able to find any locally. How do I seal a poly vapor barrier to the existing drywall. Removing the entire wall of drywall is not really an option.
We have brick facades on both sides of our garage and I'd like to add lights to both sides. Do I have to cut holes in the brick to hold junction boxes? Thanks.
It would probably be a straight shot between the floor joists to the back of the house. No more bends than there currently are. Just about 30 feet of horizontal pipe added.
I already have a check valve in place.
Thanks.
I have a sump pump in my basement and it works fine, but it dumps out in the lowest spot in my yard and I suspect a lot of the water getting pumped out is coming right back in. Is the any reason I shouldn't run the piping across the house (inside) to the back yard so it can drain in a...
So, I have to cut a 4" hole in the beam to mount the junction box? I was hoping to avoid this, but I want to do it right.
The beam is 10" deep. Do they make boxes that long? Or will I have to nail a piece of 2x4 inside the beam?
Thanks.
I want to put a ceiling fan in the our bedroom. It has a hollow beam running across the center made up of 1x12's and a 1x6.
Do I have to do anything special to attach the fan to this beam.
Can I just run the electrical cable through the beam and into the fan without using a junction box...