DIY Home Improvement, Remodeling & Repair Forum > Search Forums > Search Results




Showing results 1 to 9 of 9
Search took 0.01 seconds.
Search: Posts Made By: Precision Home Services
DIY Home Repair Forum: Decks & Patios 10-16-2012, 07:19 PM
Replies: 20
Views: 2,727
They make different and better grades of...

They make different and better grades of polycarbonate panels now that would allow light in and last longer then your original panels. The galv. panels would cut out all the light from above and...
DIY Home Repair Forum: Windows and Doors 08-23-2012, 09:48 PM
Replies: 14
Views: 2,938
I would recommend going to a roofing/vinyl...

I would recommend going to a roofing/vinyl siding/window supplier that sells to contractors and order vinyl slider replacement windows. They can be made to any size and should be made 1/4" less...
DIY Home Repair Forum: Decks & Patios 08-23-2012, 07:25 PM
Replies: 35
Views: 2,950
I would have the company pull up the boards over...

I would have the company pull up the boards over the beam area and install the proper flashing to direct water to either side, similar to Joe's recomendation. The caulking in the joints between the...
DIY Home Repair Forum: Windows and Doors 05-23-2012, 10:56 PM
Replies: 7
Views: 4,184
What you are looking for is a9"x6" glass insert...

What you are looking for is a9"x6" glass insert or door lite for a steel door. It comes as a unit--outside plastic frame sealed to the glass and then an inside plastic frame screwed into the outside...
DIY Home Repair Forum: Roofing and Siding 05-18-2012, 01:37 PM
Replies: 15
Views: 2,376
Vikasinti, I like to use the 8d CC coated nails...

Vikasinti,
I like to use the 8d CC coated nails as they have a little bit of "glue" coating which helps hold them in the wood. For the T-111 siding you would be better using the galvanized nail as...
DIY Home Repair Forum: Flooring 04-29-2012, 08:50 PM
Replies: 3
Views: 833
SPL, I would recommend checking with the...

SPL,
I would recommend checking with the manufacturer of the new floor material for installation instructions. Improper installation may void any warranty on the materials. In the meantime I found...
DIY Home Repair Forum: Decks & Patios 04-29-2012, 06:51 PM
Replies: 3
Views: 868
I would suggest that you attach the decking...

I would suggest that you attach the decking material to sleeper strips that are just laid on top of your mineral surface material, because you don't want to have any holes in this material. You...
DIY Home Repair Forum: Bricks, Masonry and Concrete 03-03-2012, 06:30 PM
Replies: 14
Views: 9,706
The cracked liner is unsafe to use! The steel...

The cracked liner is unsafe to use! The steel liners will make the flue opening smaller if they just insert them in the existing liner. The better repair method would be to remove the existing tile...
DIY Home Repair Forum: Windows and Doors 09-21-2010, 07:26 PM
Replies: 9
Views: 1,721
Bow Window support

The main support of a Bow Window is through the mull posts between each of the individual windows that make up the unit. The seat board really only finishes off the inside of the bottom. Adding the...
Showing results 1 to 9 of 9