DIY Home Improvement, Remodeling & Repair Forum > Search Forums > Search Results




Showing results 1 to 6 of 6
Search took 0.00 seconds.
Search: Posts Made By: tcampbe
DIY Home Repair Forum: Decks & Patios 05-02-2012, 07:05 AM
Replies: 2
Views: 656
Posted By tcampbe
Flashing ledger board- brick

My project continues and as I was tearing off the old deck, I discovered there was no flashing installed on the ledger board. What are my options at this point other than taking down the board or...
DIY Home Repair Forum: Decks & Patios 04-30-2012, 09:11 AM
Replies: 3
Views: 778
Posted By tcampbe
If that's the case, I can't be 100 percent level...

If that's the case, I can't be 100 percent level due to change in moisture levels. What should my tolerance be? 1/8 inch? I'm installing PVC decking.
DIY Home Repair Forum: Decks & Patios 04-30-2012, 07:37 AM
Replies: 3
Views: 778
Posted By tcampbe
Cedar shims for joists

Anyone have experience, good or bad, using cedar shims for uneven deck joists?
DIY Home Repair Forum: Decks & Patios 03-24-2012, 01:11 PM
Replies: 6
Views: 745
Posted By tcampbe
The rot i believe came from a terribly...

The rot i believe came from a terribly constructed Florida room that sat on top if it. Here are some pics. Found a 20ft piece this morning
DIY Home Repair Forum: Decks & Patios 03-20-2012, 07:38 AM
Replies: 6
Views: 745
Posted By tcampbe
Ok thanks! I think I will go with a single board...

Ok thanks! I think I will go with a single board especially since there will be a railing attached. Will probably do some blocking where the 4x4 posts will be.
DIY Home Repair Forum: Decks & Patios 03-19-2012, 12:47 PM
Replies: 6
Views: 745
Posted By tcampbe
Rim joist

I ran into some rot issues on the front rim joist of my deck. The previous owner who installed the joist had butted two 2x8s together to creat the front joist. It spans 18 ft in total. My question...
Showing results 1 to 6 of 6