DIY Home Improvement, Remodeling & Repair Forum > Search Forums > Search Results





Showing results 1 to 13 of 13
Search took 0.01 seconds.
Search: Posts Made By: Manuel Nunez
DIY Home Repair Forum: General Appliance Discussion 02-01-2006, 04:36 PM
Replies: 2
Views: 1,576
Posted By Manuel Nunez
Go to HOME DEPOT and talk to the guy in the...

Go to HOME DEPOT and talk to the guy in the cabinet department, they carry all you need to build your diswasher cabinet. Extension, diswasher end base and countertop. Still you need electrical...
DIY Home Repair Forum: Plumbing Forum 02-01-2006, 04:19 PM
Replies: 4
Views: 2,058
Posted By Manuel Nunez
Shut off hot water valve and remove supply line....

Shut off hot water valve and remove supply line. Slowly open valve to test for pressure, if not pressure, remove valve stem and see what you find wrong there. If pressurized, check supply line,...
DIY Home Repair Forum: Plumbing Forum 01-28-2006, 04:03 PM
Replies: 4
Views: 4,600
Posted By Manuel Nunez
If this new shower is going to be discharging to...

If this new shower is going to be discharging to your actual sewer line, this part must be connected to a U or trap below the floor. Drain rules may call for all drains to be traped to avoid gases...
DIY Home Repair Forum: Plumbing Forum 01-28-2006, 03:52 PM
Replies: 4
Views: 4,600
Posted By Manuel Nunez
Do you mean outside shower?. The shown PVC drain...

Do you mean outside shower?. The shown PVC drain part look like a 3 inches one, more than enough for draining your future shower. Make sure it is flushed to the floor and pitch the floor toward the...
DIY Home Repair Forum: Plumbing Forum 01-19-2006, 02:43 PM
Replies: 5
Views: 1,900
Posted By Manuel Nunez
Why does this happen?....Low capacity water...

Why does this happen?....Low capacity water heater tank. Water heater temperature set too low, allowing you to open hot water side of shower full blast. Rise temperature of water heater or shut water...
DIY Home Repair Forum: Plumbing Forum 01-17-2006, 06:14 PM
Replies: 5
Views: 2,128
Posted By Manuel Nunez
May be a crossed line, a cold water line...

May be a crossed line, a cold water line connected to the hot water line. Shut off valve at water heater and open hot water side from any faucet, if water still continue to run, you have a crossed...
DIY Home Repair Forum: Carpentry and Woodworking 01-16-2006, 10:18 PM
Replies: 11
Views: 43,755
Posted By Manuel Nunez
If these cabinets are painted with a lot of coats...

If these cabinets are painted with a lot of coats of paint over, try a heat gun to remove as much as possible coats of paint and then use the chemical remover to finish the removing steps.
DIY Home Repair Forum: Flooring 01-16-2006, 10:02 PM
Replies: 6
Views: 1,284
Posted By Manuel Nunez
Seek help from your city housing department.

Seek help from your city housing department.
DIY Home Repair Forum: Plumbing Forum 01-16-2006, 09:37 PM
Replies: 8
Views: 3,213
Posted By Manuel Nunez
Low price? I found good reliability in LAMOSA...

Low price? I found good reliability in LAMOSA from home depot.
DIY Home Repair Forum: Plumbing Forum 01-16-2006, 09:11 PM
Replies: 11
Views: 10,727
Posted By Manuel Nunez
Also check the lowerflow hole, remove scrwed...

Also check the lowerflow hole, remove scrwed cover. Use a 4 to 5 inches piece of wire with a 1/4 inche folded at the end to remove hairs from these hole. This in addition to the overflow " as posted".
DIY Home Repair Forum: Plumbing Forum 01-16-2006, 08:59 PM
Replies: 9
Views: 78,563
Posted By Manuel Nunez
I wont recommend chemicals for drain cleaning,...

I wont recommend chemicals for drain cleaning, instead, if you own a wet and dry vacuum use it to sucks the troubling matters out. It is cheap, cleaner and safer. If that fails, you have a big...
DIY Home Repair Forum: Plumbing Forum 01-16-2006, 08:43 PM
Replies: 3
Views: 1,860
Posted By Manuel Nunez
Sure you should be concerned, call the plumber...

Sure you should be concerned, call the plumber back...
DIY Home Repair Forum: Plumbing Forum 01-16-2006, 08:37 PM
Replies: 3
Views: 1,860
Posted By Manuel Nunez
There is not supposed to be flame at the base of...

There is not supposed to be flame at the base of the thermocouple or pilot line. It sounds like you have a leak in each case. Since thermocouple carry no gas, leak has to be located at pilot line...
Showing results 1 to 13 of 13