DIY Home Improvement, Remodeling & Repair Forum > Search Forums > Search Results





Showing results 1 to 5 of 5
Search took 0.00 seconds.
Search: Posts Made By: ozarkdan
DIY Home Repair Forum: Tools 05-15-2013, 10:49 AM
Replies: 19
Views: 2,579
Posted By ozarkdan
What I found out is that Electrolux bought Poulan...

What I found out is that Electrolux bought Poulan some time ago and they were the ones responsible for changes to a number of products, including the weed trimmers. Apparently they couldn't make up...
DIY Home Repair Forum: Tools 05-14-2013, 09:33 PM
Replies: 19
Views: 2,579
Posted By ozarkdan
I am providing a photo of the adjustments on the...

I am providing a photo of the adjustments on the carb. As you can see, they are spline'd and recessed. Because they are recessed, cutting slots into the ends is pretty difficult unless I find a way...
DIY Home Repair Forum: Tools 05-05-2013, 11:51 AM
Replies: 19
Views: 2,579
Posted By ozarkdan
Kind of hard to describe exactly, but the heads...

Kind of hard to describe exactly, but the heads of the adjustment screws had what looked like about 15-20 straight splines. I could put a piece of rubber tubing on them but they were too stiff to...
DIY Home Repair Forum: Tools 05-03-2013, 10:35 AM
Replies: 19
Views: 2,579
Posted By ozarkdan
Thanks very much for the feedback and ideas....

Thanks very much for the feedback and ideas. Here's what I've done: 1. I applied high temp silicone grease around the gasket/O'ring and saw no difference in starting or running. This is a trick I...
DIY Home Repair Forum: Tools 04-24-2013, 04:35 PM
Replies: 19
Views: 2,579
Posted By ozarkdan
Weed Trimmer, Runs in START, dies in RUN

I have a Poulan PPB 150E weed trimmer that wouldn't start this season unless I shot fuel into the carb past the butterfly. Then it would only run for a few seconds. I replaced the fuel lines, filter,...
Showing results 1 to 5 of 5