Search results

My bathroom vanity in an all in one which I think may be an epoxy casting. A small section of the sink surface has peeled off and I would appreciate learning if it can be fixed if it is epoxy and how to I do a repair. Thanks for your help.

This might be much about nothing but 15 years ago I strapped my basement floor and lost probably 2 inches in the process. Now after a bathroom leak, I am at it again but no strapping for me. I want to know how to use a string or a straight edge to check the floor width to width along the entire...

DVR 33 RW Direct Vent fireplace insert Worked flawlessly since 2012 when I purchased the home Grandson placed blanket on hot glass and it melted onto the glass I Removed glass for cleaning ( no luck so far) but did not disturb logs After I reinstalled door the glass the pilot gave some...

Looking for help on how to install a humidifier for my furnace to address dryness that is causing my hardwood floor to gap. I was able to minimise the problem when I had a 50-gallon fish tank. I want to install so that when the furnace comes on it activates or the blower is set to run when...

I traded in the old dishwasher for a Kitchen Aid Serial # FW4305915 and the results were dramatic. I got a quiet cycle with a fraction of the insulation and clean dishes and glasses to boot. This was 4 months ago now the top rack is not delivering clean dishes , if there is chocolate or tea...

My hot water heater (gas) is located so that I cannot get by it to get to the rest of the room. To date we have been using a cut out in an adjacent room ( my office) which is now going to become a laundry room ( much better plan). I am looking at 2 options , first I build a pocket door in the...

I need to create a neat entrance from my basement laundry room to the adjacent furnace room so that I can service my furnace periodically. There is a furnace door or opening but it is clocked off by the water heater. How do I frame and install a 24 inch pocket door ? Thanks

I saw a skylight in a new homes which resulted in an Internet search that introduced me to skytubes. In case I am not describing this product properly I am referring to an alternative involving a rigid or flexible reflective tube that is used to capture light and disperse it into a room. One...

Hello everyone I am brand new to the forum. My goal is to learn as much as I can and share what little experience I have. I am not much of a DIY but the high cost of labour demands that we all try to save a buck where we can, provided we proceed with caution. Hopefully this forum will help to...