Search results

The clips are easy to remove. there is a slot in the bottom of them for a flat head screw driver. Just turn them until the clip is loose. If you have the room you could pull the sink attached to the counter. Either way you need to disconnect all the plumbing.

Are both paints new or just the green? If just the green is new, try using Goof-off and a rag, it will break down the new paint first. or you may have to repaint the white, you will have to do that if you sand it.

The thermostat is not repairable but they are replaceable, on gas or electric. Find a dealer in your area, make sure you take the model and serial #'s with you.

sounds like a question for an exterminator

Congrads on your house purchase and welcome.

Hey Redwood, yes condensate drain is exactly what I was thinking. Only been in Fl 4 years, originally from NJ/NY but did alot of A/C up there

I do not think you will find anything with that cut to it, you will have to make it with a router or use a peice of square stock and fill the gap with wood putty.

Are you sure that this pipe is connected to the water heater?

I would use an adhesive caulk and maybe a few nails to keep it in place until the caulk dries

Just a word of caution, if you are going to HD make sure it is cellular vinyl, they may carry some cheap foam stuff. I would use a real lumber yard if you can they will let you know what thier products are made of.

I would contact the manufacturer and ask them their advise

Should not be an issue as long as you do not try to run to many heads on the same valve

First thing is go to the outside unit and see if the fan is running, if not check the breakers, still not Call an A/C repairman, you need special tools to check any further.

That great that you got it fixed but you did not explain how you had it wired that was wrong so other could learn what not to do.

$40K does sound cheap but it all depends on the area, what material is used and how desperate the contractors in the part of the country you in are.

Gadwall, that would also be a solution, I use Azek all the time, Great stuff, just think the plastic 1/4 round will be much easier and faster and will last along time.

Is the outlet half switched? another words does the switch control one of the plugs and the other one is always live? More than likely this is the case! To check this if you are not sure test the outlet with the switch off and then with the switch on! How this is wired is the power feeds into...

First thing is paint take about 30 days to full cure, so the new area should blend over time if it is the same paint. Also using a different applicator will make a difference, if the wall was painted with a roller and you try to touch it up with a brush you will se a difference at least for a...

They make plastic and cellular vinyl (which you maybe mistaking for foam) 1/4 round, they sell it at most lumber yards and online, either will be good for you application.

Unfortunatly that is a question with way to many variable for any one to even come close. you will need a contractor to look at it and give you an estimate