Search results

The thorough correction would be best but in my case it is not practical. As previously stated the other side is in the kitchen with dishwasher and cabinets.

Thank you! I think this is the best solution.

Thank you.

We have a small partition 3.5 high x 6.5 wide. The original contractor did not align the studs nor base plate. I’m going to put a partial sheet of oak faced plywood. but with the studs so out of line this task is a problem. There are maybe two stud inline. FYI, two electrical lines run there...

I've already purchased the charcoal filters for our vent hood. Btw, the new 2017 Broan is model BCDJ130WH. It has a motor on both the right and left side. We ordered it from Lowes for $405 plus $90 installation. Should be here around July 10. Should we buy an extended warranty...

Good morning Neal, re 'not to far for the fan'? Do you mean a second fan will be needed? Unfortunately, the work would have to be hired out. What price then? Thanks

This would require a 45degree turn then a run of about 10 to 12 feet then exit through a brick wall. Would the horizontal exit for the hood transition into a round duct? Would that long run need a inline fan? I image the exit through the brick would be detail oriented and expensive. Is all of...

Is there any possible way to vent a range hood into a garage and satisfy codes? I've done without permission before but with this new really expensive hood the installation company refused. The darn way our home is constructed prevents conventional vertical or horizontal venting. Really hate...

Our hood died so wife is about to have a duck. We want a high quality unit. Price max is $450. Preferred brand is Broan unless you say otherwise. Need a convertible hood as it must be installed ventless due lack of space for ducting. Must be white, 30" width. Sears Kenmore Elite electric range...

Thread moved to new post.

Thanks for all your help. Turned out the fixture was not defective. We have tried several ideas but still have not found a solution.

Based on the recommended article the accessories will be a shade of orange. Thanks!

Nordic Track Tread Mill, Recumbent Bike, stretching bands. The article is perfect.

We converted a large, long bedroom into a home gym. As you can see from the wall color we hope the colors to be eye catching and energetic. Here is a photo of the audio equipment and table. There are four items that can be repainted. Those are the speaker cabinets, table and a unseen large...

Unfortunately, the 5" front frame is there because of the original wall. I am going into hospital today so will be off line. Thanks

The material is poplar. Thank you for your help.

It is the open boxes that are out of square. For example 3/8". I did not ask my question properly. What is the best tool to use to remove out of line material from short sections of inset cabinet door boxes? Here is an example. Note: the flat panel drawer will be removed and replaced with a...

Our recently discharged remodelers built inset cabinet boxes out of square. In other words, the dimensions are somewhat irregular. Finish grade veneered 1/2 plywood is the wood. The inset shaker doors have not yet been built. All boxes are on the wall. Taking them down and rebuilding is not...

The bottom two inches of the drywall sorta developed a lip. That drywall crumbles when touched. I figure about five to six inches would need to be straight line cut and replaced with nice looking PVC board or a thin back board and the tile you suggested. All material would be glued with water...

I can confirm that it is the drywall that bulged due to moisture. Not anything to do with the shower stall walls. Areas of the wallpaper along bulged drywall mildewed. The mildew has been eradicated but the bulging drywall is flaky and created a gap between it and the top of the shower walls.