Search results

Thanks! I'll look for one. I'm back at work, so the progress has stopped. The good news though; we had a nice storm roll through last night and the attic stayed dry! No wet spots around the pipe either. I also was informed that the hood is too low/close to the grill. I now have to remove...

Thanks again for the response. I just spoke w/ a local builder here in my subdv about this, & he said being an outside vent, I just need to cut the hole a little bigger, like you said, but I don't need to put anything around the pipe. As for the plywood, I considered that, but wasn't sure if...

Wow, ask and you shall receive!! Thanks Nealtw!! I guess I should've been more specific. Here's the progress thus far... I'll be covering the entire hood with cypress planks. Therefore, I'm not really too concerned w/ the cosmetics of the pipe, just wasn't sure if I had to have a...

Good day- I wasn't sure exactly what section to put this under, so I'm throwing it up here.. I'm building a hood to go above my outdoor grill. As you can see from the picture attached, it's mounted to a brick wall, and goes up through the outdoor patio ceiling, and into the roof. My question...

Oh, the bottom, or inside of the hood will have a stainless liner around it. Also, I'll be venting this straight up, through the roof.

As luck would have it, I ran into the guy that did my cabinets inside the house. I never even thought of this guy for this project. He's going to give me an estimate. Initially, I asked for his opinion. He said Tapcons in the brick would work fine, and also suggested securing it through the...

OK, here's an old picture. The hood will be about 32" above the grill, and just a simple box type frame. [/URL]

Good morning- I'm planning on building a vent hood above my outdoor grill. The wall behind the grill is brick. I'm assuming I use pressure treated 2x4's for the framing. I have cypress for the outer shell of the hood. As for securing it to the brick wall, would I use tapcon screws, or...