ajr4997378
Active Member
- Joined
- Nov 28, 2012
- Messages
- 25
- Reaction score
- 1
I have a whirlpool electric water heater that was installed about 4-5 years ago. Recently, I noticed sometimes the water is scalding hot and other times it is just hot like it should be. I set the temp to 120 when I first had it installed. I also noticed that it sounds quieter than it used to. It used to have a louder whistling sound and now it's quieter and it keeps clicking on and off after someone takes a shower or uses a lot of hot water at a sink instead of just clicking on halfway through using water and then shuts off after about 20 minutes of not using hot water. There is a lot of cob webs around the controls. Could that be the problem or could it be something else?
Last edited: