Hi Folks,
I'm trying to update our kitchen, including refinishing our wooden cabinets. It was all built in 1987 and looks run down. I also tried to replace the cabinet pulls, but I can't find anything like them in the same size.
Here's what they look like:
As you can see, these cabinet pulls are 2.5" from center to center. Nearly all of the replacement cabinet pulls I've seen are 3" or 76 mm. I found a few cabinet pulls at online stores that are 64 mm, but they don't even look close to the ones we have.
I need a total of 26 matching pulls for this job.
I tried polishing one of them, but the antique brass finish is nearly worn off. The remaining finish looks like old pot metal - not very good, whether shiny or dull!
I've looked in all of the cabinets to see if I can find a brand name. The only one that has a brand is a corner turnstile cabinet that has a placard inside for "Amerock revolving door hardware". I checked with Amerock, and they don't have any 2.5" pulls like these now.
Has anyone else found a good solution for this problem? I've tried a number of local stores, and they all seem disbelieving that there are pulls that aren't 3 inches center to center. I'm willing to bet our whole neighborhood has these - Pulte built about 200 homes in this area when they made ours. I'm thinking they must have been fairly common back then.
Thanks for any pointers,
Scott C.
--
Scott C. in Cary, NC USA
I'm trying to update our kitchen, including refinishing our wooden cabinets. It was all built in 1987 and looks run down. I also tried to replace the cabinet pulls, but I can't find anything like them in the same size.
Here's what they look like:
As you can see, these cabinet pulls are 2.5" from center to center. Nearly all of the replacement cabinet pulls I've seen are 3" or 76 mm. I found a few cabinet pulls at online stores that are 64 mm, but they don't even look close to the ones we have.
I need a total of 26 matching pulls for this job.
I tried polishing one of them, but the antique brass finish is nearly worn off. The remaining finish looks like old pot metal - not very good, whether shiny or dull!
I've looked in all of the cabinets to see if I can find a brand name. The only one that has a brand is a corner turnstile cabinet that has a placard inside for "Amerock revolving door hardware". I checked with Amerock, and they don't have any 2.5" pulls like these now.
Has anyone else found a good solution for this problem? I've tried a number of local stores, and they all seem disbelieving that there are pulls that aren't 3 inches center to center. I'm willing to bet our whole neighborhood has these - Pulte built about 200 homes in this area when they made ours. I'm thinking they must have been fairly common back then.
Thanks for any pointers,
Scott C.
--
Scott C. in Cary, NC USA