mwshockley
New Member
- Joined
- Oct 11, 2007
- Messages
- 1
- Reaction score
- 0
I have a Bryant 383KAV that I am trying to replace the inducer motor on. I have removed the three 3 assembly mounting screws so assumably the only thing holding the motor and mount to the furnace is the motor shaft.
The next instruction says to loosen the setscrew with an allen wrench. From looking at the diagram provided the set screw is inside the housing and there is no way to get to it, i cant find any other kind of screw access from outside.
Any help?
http://i210.photobucket.com/albums/bb266/merotek/furnace_1.jpg
This is the piece I am trying to remove
http://i210.photobucket.com/albums/bb266/merotek/furnace_2.jpg
This is the piece I am putting back in
The next instruction says to loosen the setscrew with an allen wrench. From looking at the diagram provided the set screw is inside the housing and there is no way to get to it, i cant find any other kind of screw access from outside.
Any help?
http://i210.photobucket.com/albums/bb266/merotek/furnace_1.jpg
This is the piece I am trying to remove
http://i210.photobucket.com/albums/bb266/merotek/furnace_2.jpg
This is the piece I am putting back in