Folks were very helpful in a prior threat on running new pex for my cabin project. I'm up to the point where I'm getting ready to hood everything up and I'm wondering what's the best way to mount it.
I'm using 2 copper manifolds (one hot one cold), with 1/2" ball valves on each output. The issue I'm having is what's the best way to mount it given the materials and the fact that its going to be in the basement?
I was thinking of mounting everything to a piece of scrap cemement board using plastic wire clamps so that they are secure, but the clamps won't risk marring the pex. Alternatively would CDX be better?
How have other folks done this?
I'm using 2 copper manifolds (one hot one cold), with 1/2" ball valves on each output. The issue I'm having is what's the best way to mount it given the materials and the fact that its going to be in the basement?
I was thinking of mounting everything to a piece of scrap cemement board using plastic wire clamps so that they are secure, but the clamps won't risk marring the pex. Alternatively would CDX be better?
How have other folks done this?