Hi folks, I'll preface this as I do with all of my posts here:
I fall squarely into the category of "severely home improvement inept". So, if you are kind enough to respond to this thread, please assume the following:
a. If it's a tool other than a hammer, I probably need detailed instructions about what the tool is.
b. If it's something I have to buy that could POSSIBLY have more than one size, type, or model, please help me figure out exactly which one to buy, because I am genetically predisposed to selecting the wrong one!
So, in other words, while I appreciate your help in advance, please don't say "Oh, no problem, just whammus the frammus with a 3/8" circular frindebund!"
OK, caveat over, here's my story today:
In my new townhouse, the previous owners did a spotty job of installing the bathroom hardware. In two of the three bathrooms, the toilet paper holder and towel holders have either come out of the wall completely, or are on the verge of doing so. In several of the cases, the screws are actually falling out of the wall. They've been screwed right into the wall, and it looks like the holes themselves are no longer stable. Not sure if they used the wrong kind of screws, didn't hit a stud, or what.
At any rate, the bottom line is, I'd like to replace these. My questions are:
1. Once I take the existing hardware off, I won't be able to use the existing mangled holes. How do I patch up these holes?
2. For small hardware like toilet paper holders, do you need to hit a stud, or do you just use drywall screws or something?
Any other general suggestions I should think about?
Thanks!
Steve
I fall squarely into the category of "severely home improvement inept". So, if you are kind enough to respond to this thread, please assume the following:
a. If it's a tool other than a hammer, I probably need detailed instructions about what the tool is.
b. If it's something I have to buy that could POSSIBLY have more than one size, type, or model, please help me figure out exactly which one to buy, because I am genetically predisposed to selecting the wrong one!
So, in other words, while I appreciate your help in advance, please don't say "Oh, no problem, just whammus the frammus with a 3/8" circular frindebund!"
OK, caveat over, here's my story today:
In my new townhouse, the previous owners did a spotty job of installing the bathroom hardware. In two of the three bathrooms, the toilet paper holder and towel holders have either come out of the wall completely, or are on the verge of doing so. In several of the cases, the screws are actually falling out of the wall. They've been screwed right into the wall, and it looks like the holes themselves are no longer stable. Not sure if they used the wrong kind of screws, didn't hit a stud, or what.
At any rate, the bottom line is, I'd like to replace these. My questions are:
1. Once I take the existing hardware off, I won't be able to use the existing mangled holes. How do I patch up these holes?
2. For small hardware like toilet paper holders, do you need to hit a stud, or do you just use drywall screws or something?
Any other general suggestions I should think about?
Thanks!
Steve