Either Woodchuck or applianceman, maybe you could help me w/ this... I took the advise of using the ohmmeter and checking the continuity, thus found it was the burner to be replaced. I just ordered a new one. Pulled the burned one and saw the burned spot. Only problem I have is to ensure I re-connect the wires on the on the switchbox. I disconnected three of the wires including a red one now w/ re-connecting I forgot which go to which port. The particular switchbox for this burner is different than the other 3 which are accurate to the wiring diagram on the manual that came w/ the stove. H1 and H2 don't exist and the two ports which I need to re-connect correctly are not in the position as shown on the diagram either. The red wire labeled RFP2 and second brown wire labeled RF2, (these go to the right front burner), are labeled as R2 and BR10 on the manual diagram and go to the L2 and H2 positions. The actual positions on the switchbox that they must go onto are the P1 or 2 plugs. I'm guessing the red wire, (RFP1), connect onto the P1 plug and the Brown wire, (RF2), connect onto the 2 plug. Does that sound correct?
Thanks for any assistance you can give. The Kenmore range was purchased through Sears, but once the warranty expires, they offer no advise and answer no questions.
Rick