gustavovgarcia
New Member
- Joined
- Jan 15, 2006
- Messages
- 1
- Reaction score
- 0
I just replaced a thermocouple using a Honeywell standard Thermocouple for a Genesis boiler and everything seems to be working fine. My concern is that I see a flame both at the end of the thermocouple and the base of the thermocouple.
I own a three family and thus have three boilers one of which the thermocouple was replaced a few months ago by a plumber and the same exact same situation is happening on that boiler. Thus I assume it is ok or the plumber would not have left it that way.
On the boiler where the thermocouple has not been changed, I only see a flame at the end of the thermocouple.
Should I be concerned?
I own a three family and thus have three boilers one of which the thermocouple was replaced a few months ago by a plumber and the same exact same situation is happening on that boiler. Thus I assume it is ok or the plumber would not have left it that way.
On the boiler where the thermocouple has not been changed, I only see a flame at the end of the thermocouple.
Should I be concerned?