oldog/newtrick said:There are several ways. What profile crown are you installing and what type of tools do you have to cut the moulding with? What type of corners are you dealing with, square, angled?
thomask: I read that book too. Good luck finding 0.6 degrees. If you do want to cut a large crown on the flat, start with a smaller molding that fits on the saw and cut sample angles and use them to set your saw at the two angles you need. Then you would also need varrity like 44, 45, 46 and rights and lefts just for the 90 degree corners.
P.S. Saw your photos, looks great.
thomask: I read that book too. Good luck finding 0.6 degrees. If you do want to cut a large crown on the flat, start with a smaller molding that fits on the saw and cut sample angles and use them to set your saw at the two angles you need. Then you would also need varrity like 44, 45, 46 and rights and lefts just for the 90 degree corners.
P.S. Saw your photos, looks great.
Enter your email address to join: