Can't find setscrew on tub spout?

House Repair Talk

Help Support House Repair Talk:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

carmine10

New Member
Joined
Mar 9, 2015
Messages
1
Reaction score
0
Trying to replace an old Eljer tub diverter spout. There is a hole on the underside but I can't seem to find a screw. Is it possible there is not a screw and it is a twist off? Tried to twist a bit but didn't want to put too much pressure out of fear of breaking the pipe. Any advice is appreciated. Pics attached!

Spout1.jpg

Spout2.jpg
 
Spout pipes can be simple 1/2" copper ("L" or "M" grade) and even galvanized pipe nipples. If you have a stripped set screw, you might be in for some fancy metal sawing to get the spout off in pieces without cutting the supply pipe. You could do this by cutting through the set screw hole to release the spout so you can pry it off. Even then, it might be a screw in spout, so try turning it counterclockwise after releasing the set screw.

What a mess ... Good luck! I am sure the end result will be well worth the effort. :D

KID TUB.jpg
 
A Dremel would make fast work to dissect that spout. Just stay away from the pipe itself.
 
Sometimes you have to cut the diverter off and right through the pipe too.
Just come back from the diverter handle an inch or so (just behind the threads of the pipe) and the cut there.
Of course you'll have to sweat on a short section of pipe with a threaded nipple using a coupler to rebuild the pipe end.
 
Back
Top