This weekend I built a very simple table. See pic.
I didn't use the best joining method however and the wood I bought at HD was a bit warped. There are two small gaps at one end (about 1/16in).
I was planned on just leaving it but if I can I would like to get rid of them. I've already sanded and stained but haven't put the polyurethane on.
Is there a good way to do this. I'm thinking either wood filler and then sand and stain over. Or glue and then sand while it's wet to get the dust in. Then sand and stain when it dries.
Would either of these work or should I just leave it as is? I'm not looking for a perfectionist table, just something that looks decent.
I didn't use the best joining method however and the wood I bought at HD was a bit warped. There are two small gaps at one end (about 1/16in).
I was planned on just leaving it but if I can I would like to get rid of them. I've already sanded and stained but haven't put the polyurethane on.
Is there a good way to do this. I'm thinking either wood filler and then sand and stain over. Or glue and then sand while it's wet to get the dust in. Then sand and stain when it dries.
Would either of these work or should I just leave it as is? I'm not looking for a perfectionist table, just something that looks decent.