Hi all- I just bought a house, it is masonry contruction (block) and so is the detached garage. The washer/dryer are located in the garage. Currently the dryer does NOT have an outside vent, it simply has a flexible tube exiting the dryer with a cut-off piece of pantyhose banded over the end of it. This lays on the floor a couple feet from the dryer. I would like to vent it to the outside. To do this I will need to cut a square hole in the block wall and install a dryer vent.
What is the best way to cut the block to do this? Would I cut a large hole and then frame it up somehow to house the dryer vent? If so, what is the best tool/procedure for cutting the hole in the wall.
Thanks for any help,
-Ron
What is the best way to cut the block to do this? Would I cut a large hole and then frame it up somehow to house the dryer vent? If so, what is the best tool/procedure for cutting the hole in the wall.
Thanks for any help,
-Ron