Hello Folk,
Some time ago I posted about reroofing a deck whose upper framing was not ideal for a roof, so I added some extra support (beam) and added metal brackets and deck screws, etc.. Back then I was planing on using half inch plywood sheathing for the roof + epdm membrane, but due to unforeseen circumstances I will use the plywood sheathing for another future project and will instead use new galvanized roof panels (similar to the ones previously installed).
I raised the roof rafters on one end thus creating a much better slope to help drainage. But some form of flashing should be used to seal the point where the shingles meet the flat metal roof sheets.
This is an old pic, but the situation now is similar other than the fact that there is a new similar but improved roof.
Is there any special flashing made for this application
Some time ago I posted about reroofing a deck whose upper framing was not ideal for a roof, so I added some extra support (beam) and added metal brackets and deck screws, etc.. Back then I was planing on using half inch plywood sheathing for the roof + epdm membrane, but due to unforeseen circumstances I will use the plywood sheathing for another future project and will instead use new galvanized roof panels (similar to the ones previously installed).
I raised the roof rafters on one end thus creating a much better slope to help drainage. But some form of flashing should be used to seal the point where the shingles meet the flat metal roof sheets.
This is an old pic, but the situation now is similar other than the fact that there is a new similar but improved roof.
Is there any special flashing made for this application