Hello everyone,
I have a question, and I hope I can explain it in a way that makes sense.
I am attaching a photo of it, so you can see what I mean.
At the bottom of the stairs in my condo, there is a landing and a small wall (already knocked down in the photo) with an air intake vent running inside of it. I am remodeling the entire lower level, and I would love to be able to get rid of that wall and landing at the bottom of the stairs to open it all up a bit.
My question is, is there a piece that can be bought (or fabricated) so that I can basically cut the vent inside the ceiling, and turn it 90 degrees on its vertical so it will sit flush (parallel) against that cinderblock wall behind it? That way, I can frame out that cinderblock wall and then frame a "bump out" around the vent.
I hope that made some ounce of sense.
Thanks all,
H
I have a question, and I hope I can explain it in a way that makes sense.
I am attaching a photo of it, so you can see what I mean.
At the bottom of the stairs in my condo, there is a landing and a small wall (already knocked down in the photo) with an air intake vent running inside of it. I am remodeling the entire lower level, and I would love to be able to get rid of that wall and landing at the bottom of the stairs to open it all up a bit.
My question is, is there a piece that can be bought (or fabricated) so that I can basically cut the vent inside the ceiling, and turn it 90 degrees on its vertical so it will sit flush (parallel) against that cinderblock wall behind it? That way, I can frame out that cinderblock wall and then frame a "bump out" around the vent.
I hope that made some ounce of sense.
Thanks all,
H
Last edited: