Well... I'm half right..
I talked to a distributor in my area for quite a while, He was very forthcoming with the info.
This is what I gleened from our conversation, I'm sure I will be corrected again, but it's all good.This is how I learn.
The spray on has to be preped like it is a new building. All damage and decay must be replaced, not repaired.Then the building has to have all interior moisture problems eradicated.
Then the building can be preped with the primer, then the paint siding.
This stuff aparently can expand 500 times before failure, kind of like a rubber band.
It is slightly vapor permiable, aparently enough to get minor amounts of water out.It is also only installed on wood, no steel or concrete.WHY? To many moisture problems.....HMMMMM......
However..... If ALL the criteria for the install is not met.. you can have major failure of the wood behind. This stuff actually bonds to the wood itself and gets into the pours.
This is where I personally have the problem.If you have failures they will show up as large bubbles full of water. I know folks dont even look at maintinence on thier homes in the real world.When are they going to notice these problems behind bushs and up high over a roof,or when they only drive into the garage every night?
I know all contractors are the best at what they do right?
That's why there are no problems in the building industry today, just hunky dorey.
The installations from contractors who do not follow protocol are where we end up with the bad installations.This guy even stated that this is where the problems are THROUGHOUT this industry.
So if he knows there are problems with the installs why dont they fix the material to be goof proof?
So I officially apologize to the Irate gentleman and his perfect installs.May he enjoy many more dinners.
I would still NEVER install this on my home.
InspectorD