I have a TempStar furnace with Honeywell sv9500m-2682 smart valve.
I replaced my igniter a couple years ago and had some of the typical problems where it would click and not ignite until moving the molex connector where the igniter connects to the smartvalve.
I now have a new problem. The pilot ignites no problem. The inductor motor comes on and I tested that the switch closes when it comes on. After a while the blower comes on, but the burners never ignite.
Can anyone tell me how I can test the smartvalve or what else I can test to determine what has gone wrong?
I replaced my igniter a couple years ago and had some of the typical problems where it would click and not ignite until moving the molex connector where the igniter connects to the smartvalve.
I now have a new problem. The pilot ignites no problem. The inductor motor comes on and I tested that the switch closes when it comes on. After a while the blower comes on, but the burners never ignite.
Can anyone tell me how I can test the smartvalve or what else I can test to determine what has gone wrong?
