My new tile floor is ~1/2" taller than the original and my 6x10" wall register doesn't fit the existing ductwork.
Is there an easy way to adjust them? I consider just using a cutting wheel to remove the 1/2" from the base. Any easy ways to adjust the vents or the ductwork? The way that the ducts are installed, I would be cutting out plaster if I had to raise the ductwork to match the registers. Ugghjh.
Thank you,
Brian
Is there an easy way to adjust them? I consider just using a cutting wheel to remove the 1/2" from the base. Any easy ways to adjust the vents or the ductwork? The way that the ducts are installed, I would be cutting out plaster if I had to raise the ductwork to match the registers. Ugghjh.
Thank you,
Brian