I replaced a bathtub faucet that never fully switched from bath to shower (water seemed to flow quite freely from the faucet with the switch pulled up.)
I think I have done everything correctly and used plenty of plumbers tap on slip fit adapter.
Now, not a lot of water is flowing but a small steady stream once the shower is turned on will drip from the back of the faucet and out of the hole where I tightened the set screw.
I'm a novice at this trying to impress my wife so any advice would be helpful, I have thoughts that maybe I stripped the plastic threading on the inside of the faucet... Let me know guys, I'd appreciate it!
I think I have done everything correctly and used plenty of plumbers tap on slip fit adapter.
Now, not a lot of water is flowing but a small steady stream once the shower is turned on will drip from the back of the faucet and out of the hole where I tightened the set screw.
I'm a novice at this trying to impress my wife so any advice would be helpful, I have thoughts that maybe I stripped the plastic threading on the inside of the faucet... Let me know guys, I'd appreciate it!