This is a bit tricky, but any feedback would be appreciated. A couple days ago, I had to flip a few different circuits on the breaker to find out which was the downstairs bathroom. Not a good idea, I know, but we are new to the house and there was no existing floorplan for the breaker. Well I found the right one, and everything was fine. Until I noticed that the upstairs master bathroom outlets were no longer working. The panels are a combo that have both a light switch and two outlets (see attached picture for example). The light switches DO still work, but the outlets in that room do not. I tried a hair dryer in another room and it works fine. None of the circuits on the breaker seem to need flipping again. I did see in the garage, where the breaker is, that one outlet was GFCI, so I reset it, but nothing happened. Anything else I can try short of calling out an electrician?